Round tapered aluminum general purpose pole for up to 39-foot mounting heights.
Shaft: The shaft is spun tapered from seamless 6063 alloy aluminum tubing and heat treated to a T6 temper. Circumferential satin-brushed finish. Round in cross-section down length of shaft and cone tapered to the butt diameter.
Anchor base: Cast from A356 aluminum alloy and heat treated to T6 temper. Base plate and shaft are circumferentially welded top and bottom.
Anchor bolts: Fabricated from carbon steel bar with minimum-yield strength of 55,000 psi. Bolts have an "L" bend on lower end and are galvanized a minimum of 12 inches on the threaded end per ASTM A-153. Each anchor bolt is furnished with two hex nuts and two flat washers.
Grounding: Provision located inside hand hole rim. Grounding hardware is not included (provided by others).
Hand hole: A nominal 3" x 5" or 4" x 6" reinforced flush covered hand hole is centered 18" above the base.
Hardware: Stainless steel.
Top cap: Removable top cap provided with drill-mount poles.
Bolt covers: A356 bolt covers included with anchor base unless otherwise specified.
Finish: Must specify finish.
Check out POLESCENTRAL for additional resources and solutions.